Air replacement ventilation unit with anti-mould function and air decontamination with 5 speed heat recuperator with a flow rate'air of 40 m3/h
100% secure payments
Enclosure in expanded polypropylene material (PPE).
• Internal panel in self-extinguishing V0 aesthetic plastic polymer (ABS), lined internally with heat-insulating material.
• Low voltage EC fan motor with shaft mounted on ball bearings.
• 5 speeds with different flow rates: 10 m3/h; 16 m3/h; 22 m3/h; 30 m3/h and 40 m3/h.
• High efficiency storage type heat exchanger made of ceramic material.
• External grille molded in rubber, which can be mounted from the inside through the hole in the wall.
• Separate anti-insect net, which can be inserted into the duct together with the external grille at the time of installation.
• Internal air intake made on the perimeter of the front panel.
• Circular section air delivery mouth with a nominal diameter of 160 mm.
• Target wall depth: 300 mm. Using the specific optional kit, it is possible to install them on walls with a depth of up to 700 mm.
• Washable G3 filter, easily accessible for maintenance.
• No controls on board the product
• Arrangement for wall wiring;
• Controlled by means of a built-in "RC" control unit (code 22693), which can be housed in a standard 503 box, including a power supply suitable for the simultaneous management of up to 4 devices which allows the product to be switched on/off, mode selection of operation, the remote control of up to 4 products at the same time thanks to an electronic board with power supply. The device includes LEDs for diagnostics and signaling of filter blockage.
• 3 operating modes:
o Ventilation with heat recovery;
o Ventilation with air extraction only;
o Ventilation with air inlet only.
• Possibility of automatic operation by installing optional temperature and relative humidity sensors.
DATA SHEET
